JB/T 8006.4-1999 Machine tool fixture parts and components movable handle clamping screws
Basic Information
Standard ID:
JB/T 8006.4-1999
Standard Name: Machine tool fixture parts and components movable handle clamping screws
Chinese Name:
机床夹具零件及部件 活动手柄压紧螺钉
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Introduction to standards:
JB/T 8006.4-1999 JB/T 8006.4-1999 Machine tool fixture parts and components movable handle clamping screw JB/T8006.4-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of ChinaWww.bzxZ.net
Parts and components of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jigs and fixturesMovable handle holddown screw
This standard specifies the movable handle holddown screw with thread specifications of M6 to M24. 2 Dimensions
The dimensions are shown in the following figure and table.
National Machinery Industry Corporation 1999-08-06 approved 34
JB/T8006.4—1999
Replaced JB/T8006.4—1995
2000-01-01 implemented
3 Marking
3.1 Marking example:
JB/T8006.4—1999
d=M12, L=60mm A-type movable handle clamping screw AM12×60 JB/T8006.4—199990
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.