title>JB/T 5817.2-1991 Types and dimensions of wire and cable stranding equipment - JB/T 5817.2-1991 - Chinese standardNet - bzxz.net
Home > JB > JB/T 5817.2-1991 Types and dimensions of wire and cable stranding equipment
JB/T 5817.2-1991 Types and dimensions of wire and cable stranding equipment

Basic Information

Standard ID: JB/T 5817.2-1991

Standard Name: Types and dimensions of wire and cable stranding equipment

Chinese Name: 电线电缆绞制设备 型式尺寸

Standard category:Machinery Industry Standard (JB)

state:Abolished

Date of Release1991-10-17

Date of Implementation:1992-10-01

Date of Expiration:2008-11-01

standard classification number

Standard Classification Number:Electrical>>Electrical Production Equipment>>K91 Electrical Material Production Equipment

associated standards

alternative situation:Replaced by JB/T 5817.2-2008

Publication information

other information

Focal point unit:Shanghai Cable Research Institute

Introduction to standards:

This standard specifies the types and dimensions of wire and cable stranding equipment. JB/T 5817.2-1991 Types and dimensions of wire and cable stranding equipment JB/T5817.2-1991 Standard download decompression password: www.bzxz.net

Some standard content:

Mechanical Industry Standard of the People's Republic of China
Wire and Cable Twisting Equipment
Type and Dimensions
Part 2 Bundle Twisting Equipment
Subject Content and Scope of Application
This standard specifies the type and dimensions of wire and cable bundle twisting equipment. JB/T5817.2—91
This standard is applicable to the design, manufacture, acceptance, identification and quality assessment of bundle twisting equipment for twisting conductors and cable cores of wires and cables.
This standard should be used together with JB/T5814.3 "Basic Parameters of Special Equipment for Wires and Cables Part 3 2 Models
The model of the bundle twisting machine is shown in Table 1.
The model of the bundle twisting machine is shown in Figure 1.
Z type;
3 Dimensions
3.1 General dimensions
1—Conductor or cable core,
Take-up reel
Conductor bundle twisting machine, Type B
Conductor bundle twisting machine, Type H
Cable core twisting machine, Type Z
Core bundle twisting machine, Type H
3.1.1 The dimensions of the pay-off reel and the take-up reel shall comply with the provisions of GB4004 and GB4005. The technical requirements of the PND type reel shall comply with the provisions of JB/DQ8193. Www.bzxZ.net
3.1.2 The dimensions of the pay-off device are to be determined.
3.2 Rotating body
3.2.1JS series
Type as shown in Figure 2
Approved by the Ministry of Machinery and Electronics Industry on October 17, 1991 and implemented on October 1, 1992
Dimensions should comply with the provisions of Table 2.
Specifications of cable drums
Additional instructions:
JB/T5817.291
Z type;
This standard was proposed and managed by the Shanghai Cable Research Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted by the Machinery Branch of Zhengzhou Cable Factory and other units. The main person in charge of this standard is Li Jing.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.