Optimum diameters of leads of capacitors and resistors
Basic Information
Standard ID:
SJ 2420-1983
Standard Name:Optimum diameters of leads of capacitors and resistors
Chinese Name:
电容器和电阻器引出线的优选直径
Standard category:Electronic Industry Standard (SJ)
state:in force
Date of Release1983-12-05
Date of Implementation:1984-06-01
standard classification number
Standard Classification Number:General>>Standardization Management and General Provisions>>A01 Technical Management
associated standards
Procurement status:eqv IEC 301-71 (revised in 1972)
Publication information
other information
Introduction to standards:
SJ 2420-1983 Preferred diameters of capacitor and resistor lead wires SJ2420-1983 standard download decompression password: www.bzxz.net
Some standard content:
The Ministry of Electronics Industry of the People's Republic of China Standard SJ2420-83
III IEC301
Preferred diameter of capacitor and resistor lead wires 1983-12-05 Issued
1984-06-01 Implementation bzxz.net
Ministry of Electronics Industry of the People's Republic of China
Ministry of Electronics Industry of the People's Republic of China Standard SJ2420-83
III IEC--301
1971 Second Edition)
(Revised No. 1972.12)
Preferred diameter of capacitor and resistor lead wires This standard specifies the preferred diameter of capacitor and resistor lead wires. The wire diameter used to manufacture the lead terminal may not necessarily comply with the provisions of this standard.
Preferred diameter of lead wire
Minimum size
Nominal diameter
Published by the Ministry of Electronics Industry of the People's Republic of China on December 5, 1983 Maximum size
Implemented on June 1, 1984
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.