JB/T 3411.119-1999 Dimensions of positioning shaft for face milling cutter
Basic Information
Standard ID:
JB/T 3411.119-1999
Standard Name: Dimensions of positioning shaft for face milling cutter
Chinese Name:
端面铣刀定位轴 尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Machine Tools>>25.080.01 General Machine Tools
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories
associated standards
alternative situation:JB 3536-1983
Procurement status:neq ISO 2940/Ⅰ:1974
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 3411.119-1999 This standard is a revision of JB 3536-83 "Dimensions of face milling cutter locating shafts". Only the following points were modified during the revision, and the main technical content remained unchanged: - Writing format; - Standard name plus English; - Relevant reference standards and related content; - Thread drawing method. This standard is not equivalent to ISO 2940/:1974 "Milling cutter matching dimensions for 7/24 taper shank centering arbor" This standard specifies the type and size of face milling cutter locating shafts. JB/T 3411.119-1999 Dimensions of face milling cutter locating shafts JB/T3411.119-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC5 25.00.01
Mechanical Industry Standard of the People's Republic of China
IB/T 3411.101-3411.127—1999 Accessories for milling machines
Accessories afmilling maclhincs1999-05-2U IssuedbzxZ.net
National Machinery Industry Bureau
2000-01-01 Implementation
Mechanical Industry Standard of the People's Republic of China
Location shaft for tacing (ype rutler Dinensions This standard specifies the type and size of the end face of the locating shaft. 2 References
FB.3411.119-1
3536X1
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid: all standards are subject to revision, and the parties using this standard should explore the possibility of using the version with the lower mark. GBT3837.3-19837:24 Relay connection [its taper type and size]
The type and size shall be as specified in the following figure and table. s
7-26 Tennis
Note: The end core shape of the locating shaft is determined by the design, printing time:
:24 Example
Spindle number
107 ys
Limit deviation
Moved: 24 National small work order in accordance with GB3837.3 regulations, mark
Marking example:
Handle for: 21 round can 40 face piece knife positioning rail positioning shaft 40/piece 341:.1191999
National Machinery Industry Bureau 1909-05-20 approved 160
Temperature m force R inch
2000-01-01 implementation
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.