JB/T 2462.2-1999 This standard is a revision of JB 2463-78 "Dimensions, parameters and interchangeable dimensions of multi-axis turret power boxes, common components of modular machine tools". Only editorial modifications have been made according to relevant regulations, and the main technical content has not changed. This standard specifies the series parameters and dimensions of multi-axis turret power boxes for modular machine tools. This standard is applicable to multi-axis turret power boxes used as automatic lines for turret-type modular machine tools. This standard was first issued in 1978. JB/T 2462.2-1999 Parameters and dimensions of multi-axis turret power boxes, common components of modular machine tools JB/T2462.2-1999 Standard download decompression password: www.bzxz.net

1C25.6.99
Machinery Industry Standard of the People's Republic of China
JB/12462.1~2462.28-1999
Common Components for Combined Machine Tools
Published on 1990-05-21
State Machinery Industry Bureau
2(MI-01-1 Implementation
JH/T2462.2-1999bzxZ.net
This standard is revised on the basis of B246378 "Multi-speed transmission tower size, number, and change size of common parts of modular machine tools".
This standard is consistent with the technical content of 1746378, and the material has been re-selected according to the relevant or specified regulations. This standard is implemented in place of JB2463-78. The standard was proposed by the National High-speed Cutting Machine Tool Standardization Technical Committee. The standard was issued by the National High-speed Cutting Machine Tool Standardization Technical Committee This standard is issued by the Combined Machine Tool Research Institute of the People's Republic of China. This standard was first issued in 1978.
1 Standard of the People's Republic of China Machine Tool Industry Standard of Combined Machine Tools Common Parts
Multi-axis turret power box
Parameters and dimensions
This standard specifies the system parameters and dimensions of the multi-axis turret power box of the combined machine tool and its automatic speed turret power box. 2 Referenced standards
JET 2462.2-1999
Code#1B2463-78
The above standards contain the texts, which will be the provisions of this standard through reference in this standard. When this standard is revised, the version shown is valid. Some standard departments will revise the standard. The parties using the standard should consider the possibility of using the latest version of the following standards. Half-key type size
GRT1091979
J2462.1-199 group The nominal size of the multi-axis turret dynamic parameters of the machine is expressed by the corresponding sliding table width B, and five specifications are adopted: 220mm, 40Umm, 50mm6mm, and mm.
4 Vertical numbers and interconnection dimensions
The dimensions of the multi-axis turret dynamic pin energy plate are the same as those in 242.1, and the common numbers and interchangeable dimensions of the bottom plate are in the table, all of which are specified in the specification.
Lack of support dimensions
3: 4: 5; 6
3: 4: 5; 6
3: 4: 3: 6
Tusu Machinery Industry 1099-05-20 approved the principal
12 x14
12×minus 14
12×18
[4× 1s
IGixi8
2000-D1-01 head application
all positioning financial effects
JE/T2462.2-1999
plastic to GR/T 1G96 -1SF%.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.