title>JB/T 2403.1-1996 Roll forging machine parameters - JB/T 2403.1-1996 - Chinese standardNet - bzxz.net
Home > JB > JB/T 2403.1-1996 Roll forging machine parameters
JB/T 2403.1-1996 Roll forging machine parameters

Basic Information

Standard ID: JB/T 2403.1-1996

Standard Name: Roll forging machine parameters

Chinese Name: 辊锻机 参数

Standard category:Machinery Industry Standard (JB)

state:in force

Date of Release1996-04-11

Date of Implementation:1996-10-01

standard classification number

Standard Classification Number:Machinery>>General Processing Machinery and Equipment>>J62 Forging Machinery

associated standards

alternative situation:JB 2403-79

Publication information

other information

Focal point unit:Jinan Foundry and Forging Machinery Research Institute

Publishing department:Jinan Foundry and Forging Machinery Research Institute

Introduction to standards:

This standard specifies the parameters of roll forging machines. This standard applies to newly designed roll forging machines. JB/T 2403.1-1996 Roll forging machine parameters JB/T2403.1-1996 Standard download decompression password: www.bzxz.net

Some standard content:

Machinery Industry Standard of the People's Republic of China
JB/T2403.1—96
Roll Forging Machine Parameters
Published on April 11, 1996
Ministry of Machinery Industry of the People's Republic of China
Implemented on October 1, 1996
Machinery Industry Standard of the People's Republic of China
Roll Forging Machine
1 Subject Content and Scope of Application
This standard specifies the parameters of roll forging machines.
This standard applies to newly designed roll forging machines. 2 Roll Forging Machine Parameters
2.1 The main parameter of the roll forging machine is the nominal diameter of the forging die. 2.2 Roll forging machine parameters shall comply with the following figure and table. Forging die nominal diameter D
Nominal force P
Forging roll diameter d
Forging roll available width B
Forging roll revolutions n
Forging roll center distance adjustment AA (not less than) Forgeable square bad side length H
Note: [Type is suitable for roll forging machines with manipulator loading and unloading, and Type II is suitable for roll forging machines with manual loading and unloading. Additional remarks:
This standard was proposed and managed by Jinan Foundry and Forging Machinery Research Institute. This standard was drafted by Guiyang Forging Machinery Research Institute. The main drafter of this standard was Liu Qingan.
Approved by the Ministry of Machinery Industry on April 11, 1996
JB/T2403.1-96
Replaced JB2403-79
19%-10-01 implemented
Mechanical Industry Standard
Roll Forging Machine Parameters
JB/T2403.1-96
Published by the Mechanical Science Research Institute
Printed by the Mechanical Science Research Institute
(Beijing No. 2, South Ti Road, Beijing, Postal Code 100044)*
Format 880×12301/16 Printing Sheet 1/2 Word Count 2000First Printing in October 1996
First Edition in October 1996
Print Quantity 00,001-500bzxz.net
Price 5.00 Yuan
No. 96-028
Mechanical Industry Standard Service Network: http/AvwwJB.ac.cn96
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.