title>JB/T 8043.3-1999 Plunger for plastic fixtures of machine tool parts and components - JB/T 8043.3-1999 - Chinese standardNet - bzxz.net
Home > JB > JB/T 8043.3-1999 Plunger for plastic fixtures of machine tool parts and components
JB/T 8043.3-1999 Plunger for plastic fixtures of machine tool parts and components

Basic Information

Standard ID: JB/T 8043.3-1999

Standard Name: Plunger for plastic fixtures of machine tool parts and components

Chinese Name: 机床夹具零件及部件 塑料夹具用柱塞

Standard category:Machinery Industry Standard (JB)

state:in force

Date of Release1999-08-06

Date of Implementation:2000-01-01

standard classification number

Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)

Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture

associated standards

alternative situation:JB/T 8043.3-1995 (original standard number GB/T 2258-1991)

Publication information

other information

Focal point unit:Mechanical Science Research Institute

Introduction to standards:

JB/T 8043.3-1999 JB/T 8043.3-1999 Machine tool fixture parts and components Plunger for plastic fixtures JB/T8043.3-1999 Standard download decompression password: www.bzxz.net

Some standard content:

ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
1 Scope
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesPlug for plastic fixture
This standard specifies the plungers for plastic fixtures with a specification of 10~20mm. 2 Reference standards
JB/T8043.3—1999
Replaces JB/T 8043.3—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T 699—1988
JB/T 8043.1—1999
JB/T 8043.2—1999
JB/T8044—1999
3 Dimensions
Technical conditions for high-quality carbon structural steel
Machine tool fixture parts and components Hexagonal head screws for plastic fixturesMachine tool fixture parts and components Hexagonal head screws for plastic fixturesTechnical requirements for machine tool fixture parts and components
The dimensions are shown in the following figure and table.
JB/T 8043.1
JB/T8043.2
Approved by the State Bureau of Machinery Industry on August 6, 1999 and implemented on January 1, 2000
Note: The deviation of D shall be indicated on the assembly drawing.
4 Technical conditions
M10 left
M12 left
M16 left
4.1 Material: 45 steel as per GB/T699°. 4.2 Heat treatment: 35~40HRC. bzxz.net
4.3 Other technical conditions as per JB/T8044. 5 Marking
5.1 Marking example:
JB/T8043.3—1999
Plunger for plastic fixture with D=15mm, L=40mm: Plunger 15×40JB/T8043.3—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.