GB/T 11606.15-1989 Environmental test methods for analytical instruments High temperature storage test
Basic Information
Standard ID:
GB/T 11606.15-1989
Standard Name: Environmental test methods for analytical instruments High temperature storage test
Chinese Name:
分析仪器环境试验方法 高温贮存试验
Standard category:National Standard (GB)
state:Abolished
Date of Release1989-03-31
Date of Implementation:1990-03-01
Date of Expiration:2007-12-01
standard classification number
Standard ICS number:Test >> 19.040 Environmental Test
Standard Classification Number:Instruments and meters>>Material composition analysis instruments and environmental monitoring instruments>>N50 Material composition analysis instruments and environmental monitoring instruments comprehensive
Publication information
other information
Review date:2004-10-14
Drafting unit:Beijing Analytical Instruments Institute
Focal point unit:National Technical Committee for Industrial Process Measurement and Control Standardization
Publishing department:China Machinery Industry Federation
competent authority:China Machinery Industry Federation
Introduction to standards:
GB/T 11606.15-1989 Environmental test methods for analytical instruments High temperature storage test GB/T11606.15-1989 Standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Environmental test method for analytical instruments
High-temperature storage test
The method of environmental test for analytical instrumentsHigh-temperature storage test1 Subject content and scope of application
GB11606.15--89
This standard specifies the test conditions and test methods for the high-temperature storage test of analytical instruments (hereinafter referred to as instruments). This standard is applicable to assessing the adaptability of fully packaged instruments for transportation and storage under high-temperature environmental conditions. 2 High-temperature storage test condition grouping
3 Test conditionsWww.bzxZ.net
3.1 Requirements for test equipment
3.1.1 The test box (room) shall be able to provide the temperature specified in Chapter 2 of this standard in its working space, with an allowable error of ±2. The instrument shall not be directly radiated by any heating and cooling elements. 3.1.3 The volume of the test box (room) shall be greater than 3 times the volume of the instrument. 4 Test method
Pretreatment
Put the instrument in normal (or reference) environmental conditions to achieve temperature equilibrium. 4.2 Test
Put the instrument in the test box (room), then raise the temperature of the test box (room) to the specified value at an average temperature change rate of less than 1℃/min, and keep it for 8h.
4.3 Recovery
After the test, the instrument remains in the test box (room), and the temperature of the test box (empty) is lowered to normal (or reference) environmental conditions at an average temperature change rate of less than 1℃/min. The recovery time is 8h. 4.4 Final inspection
Inspect the instrument according to the relevant standards. GB/T11606.15—1989 “Analytical Instrument Environmental Test Method High Temperature Storage Test” Amendment No. 1 This amendment was approved by the State Administration of Quality and Technical Supervision on July 19, 2000 in the document [2000] No. 108, and will be implemented on December 1, 2000. 1. Add one more article between the original Articles 4.1 and 4.2, which is numbered as Article 4.2. 4.2 Initial Inspection
Inspect the instrument according to the relevant standards. 2. The order of the original Article 4.2 and the following articles shall be modified accordingly.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.