JB/T 10117.3-1999 Machine tool fixture parts and components external center
Basic Information
Standard ID:
JB/T 10117.3-1999
Standard Name: Machine tool fixture parts and components external center
Chinese Name:
机床夹具零件及部件 外拨顶尖
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10117.3-1999 This standard specifies the external turning centers with Morse taper of 2 to 6. This standard was first issued in 1983 as JB 3389-83 and revised for the first time in 1991 as GB/T 12880-91. JB/T 10117.3-1999 External turning centers for machine tool fixture parts and components JB/T10117.3-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC5 28.060.41
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
National Bureau of Machinery Industry
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
Outside draft eentre
This standard specifies the outside draft 2 with the number of 2~6. Reference Standards
JB/T2D117.3-1999
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are all valid. All standards will be revised. Parties using this standard should consider the possibility of using the latest versions of the following standards: GB[298-1986 Technical conditions for carbon layer system GB/T1443-1996 Machine tool and 1. Self-clamping round flies for trees JB/T8044-1999 3 Dimensions Technical requirements for machine tool fixture parts and components Dimensions are shown in the following figure and table.
Shanghai Steel System
Guohao Machinery Industry Bureau 1999-08-06 Approved 300
2000-01-0 Implementation
1 Technical Conditions
4.1 Material: T8 in accordance with the provisions of JB/T1298, JB/T10117.3-19
4.2 Heat treatment: 55~60HRC, chain handle 4045HRC4.3 Other technical conditions in accordance with the provisions of JBT8044. s Marking
5.1 Marking Example:www.bzxz.net
Mohs Circle 4x4 Outer Dial Item Parent:
Top 4BT10117.3-1
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.