JB/T 8774.2-1998 JB/T 8774.2-1998 Machine tool electrical system accessories cable tie holder JB/T8774.2-1998 Standard download decompression password: www.bzxz.net
Some standard content:
Machinery Industry Standard of the People's Republic of China JB/F8774.1--8774.15—1998 Machine Tool Electrical System Accessories 1998-07-17 Issued National Machinery Industry Bureau 1998-12-01 Implementation JB/T8774.2-1998 This standard is formulated on the basis of summarizing the experience of many years of production of machine tool electrical system accessories cable tie library. Products produced according to this standard will comply with the relevant provisions of GB/T5226.1-1996 Industrial Machinery Electrical Equipment Part 1: General Technical Conditions This standard is proposed by the National Metal Cutting Machine Tool Standardization Technical Committee: This standard is issued by the Beijing Machine Tool Research Institute of the Ministry of Machinery Industry. This standard is issued by: Beijing Machine Tool Research Institute of the Ministry of Machinery Industry, Zhejiang Taizhou Yunjin Electric Plastic Co., Ltd., Beijing No. 1 Machine Tool Factory, Beijing No. 2 Machine Tool Factory 1 Scope Machinery Industry Standard of the People's Republic of China Machine Tool Electrical System Accessories Cable Tie Seat JB/T 8774.2—1998 This standard specifies the dimensions, markings, technical requirements, tests and inspections of the cable tie seat for the auxiliary cable tie of the machine tool electrical system. This standard is applicable to the cable tie seat for fixing cable ties in the electrical system of machine tools, and other mechanical electrical systems shall refer to it. 2 Referenced Standards The texts contained in the following standards constitute the provisions of this standard by being cited in this standard. When this standard is issued, the versions shown are all valid. All standards are subject to revision, and the parties using this standard should explore the possibility of using the latest version of the following standards. HG/T2349-92 Polyamide 1010 resin 3 Main dimensions Main dimensions of cable tie holder 1 leather table 1. Used Wire harness model cabinetwww.bzxz.net >1--30 >3f-5h >6c -gc National Machinery Industry Bureau 1 Ming--1 approved 1998-12-01 implementation JD/T 8774. 2 The marking of the cable tie holder is represented by the name and L total standard number. As shown in the cable tie mark of 18, JB/T8774,2..1998 Cable tie seat 18 5 Technical requirements 5.1 The material of the cable tie warehouse shall meet the requirements of HC:/T2349 5.2 The surface of the cable tie seat shall be semi-smooth and smooth, and shall not have defects such as pores, hair and impurities. 6 Test and inspection , 1 The material, size (grid), processing quality, etc. of the cable tie seat shall comply with the provisions of Chapter 3 and Section 5. 6.2 The cable tie warehouse shall meet the following requirements during the test, a tensile strength 4900N, V) Low temperature -40℃, no breakage, Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.