JB/T 9982-1999 This standard is a revision of ZB J61 005-88 "Types and basic parameters of flip (table) mold-pulling machines". During the revision, only editorial changes were made according to relevant regulations, and the main technical content remained unchanged. This standard specifies the types and basic parameters of flip (table) mold-pulling machines. This standard applies to flip (table) mold-pulling machines used for molding and core making in foundries. This standard does not apply to top box (plate) mold-pulling machines and special mold-pulling machines in the same working position as molding machines and core making machines. This standard was first issued in April 1988. JB/T 9982-1999 Types and basic parameters of flip (table) mold-pulling machines JB/T9982-1999 Standard download decompression password: www.bzxz.net

ICS77.180
Machinery Industry Standard of the People's Republic of China
JB821999
Turning (Tray) Die-casting Machine
Type and Basic Parameters
1999-05-14 Issued
National Bureau of Machinery Industry
2000-01-01 Implementation
JB9982—1999
This standard is a revision of ZBJ6005-Turning (Tray) Die-casting Machine Type and Basic Parameters. During the revision, editorial changes were made according to relevant regulations. The technical content has not changed. This standard actually replaces 7A6105. This standard was proposed and managed by the National Casting Machine Standardization Technical Committee. The responsible unit for this standard: Jinan Casting Press Research Institute. This standard was first issued in April 1988.
Machinery Industry Standard of the People's Republic of China
Turning (table) demoulding machine
Types and basic parameters
This standard stipulates the types and basic parameters of turning (table) demoulding machines. This standard is applicable to the turning (rolling) demoulding machine used for casting, turning and core making. This standard does not apply to the work box [plate core mold machine and the special demoulding machine in the same position as the mold setting machine and core making machine. Type
JB/T9982-1999
Generation ZJ6100588
The turning (rolling) demoulding machine is divided into three types (including different distribution forms of the spokes and different inlet and outlet directions) 8) Closed type turning point demoulding machine (see Figure 1; b) Open type turning demoulding machine (see Figure 2): Pin type turning core demoulding machine (see Figure 3 1
Figure 1 Closed type turning demoulding machine
Figure 21 Type grinding type turning demoulding machine
Guohao Machinery Industry 1999-05-14 Approved 2000-01-01 Implementation
3 Basic parameters
Figure 3 Type flip mold lifting
3.1 The number of flip (table) mold lifting machine is the rated load, 3.2
The number of flip (bamboo) mold lifting machine should comply with the provisions of Table 1
Improvement type flip mold lifting machine
Basic parameters
Rated load quotient·
Nominal inner size of the foundation box
Allowed sand box maximum size
Other types of constant minimum size
1. The distance between the lower working table and the positive tightening force is not less than
Action time is not large
Open type micro flip super convenient machine
Type super mold machinebzxz.net
【) The rated load quotient is only the total weight of 1 working table, 2
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.