JB/T 10117.5-1999 Machine tool fixture parts and components clamping type internal cone hole center
Basic Information
Standard ID:
JB/T 10117.5-1999
Standard Name: Machine tool fixture parts and components clamping type internal cone hole center
Chinese Name:
机床夹具零件及部件 夹持式内锥孔顶尖
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10117.5-1999 This standard specifies clamping internal taper centers for workpieces with a diameter of 4 to 95 mm. This standard applies to front centers with pneumatic or hydraulic tailstock lathes. This standard was first published in 1983 as JB 3391-83 and first revised in 1991 as GB/T 12882-91. JB/T 10117.5-1999 Machine tool fixture parts and components clamping internal taper centers JB/T10117.5-1999 standard download decompression password: www.bzxz.net
Some standard content:
IC5 28.060.41
Mechanical Industry Standard of the People's Republic of ChinabZxz.net
Parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
1Scope
Mechanical Industry Standard of the People's Republic of China
Parts and units of jigs and fixtures
The parts and units of jigs and flurrsHuldiaginnertaperholecentre
The small standard bottle standard is applicable to 1 piece of held internal chain ugly center with a diameter of 4~95mm. 2 Referenced Standards
JR/T10117.5-1999
The above standards contain the specifications, which constitute the content of this standard by reference in this standard. When this standard is revised, the versions shown are valid. All standards are subject to revision, so parties using this standard should consider the possibility of using the latest version of the standard. GD/T1298--1986
JB/T 8044—1999
3 Dimensions
Technical conditions for carbon steel boilers
Technical requirements for machine tools and their components The dimensions are shown in the following table.
Circle Machinery Industry 1999-08-0% Approval 50-
2000-01-01 Implementation
Nominal diameter
Applicable month 1 Part diameter:
4 - 10
B - 24
56 - 75
701 -93
4 Technical conditions
4.1 Material: T8 in accordance with GB/T1298, 4.2 Heat treatment: 55 -60 HRC
4.3 Other technical conditions in accordance with JB/T8044. 5 Marking
5.! Marking example:
IH/10117.5-1999
Clamp-on internal pin hole with nominal diameter of 22~40mm Original fire: Original tip 22-40JB/10117.5—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.