This standard specifies the types, dimensions and selection requirements of split-type four-stud oblique sliding bearing seats. This standard is applicable to split-type four-stud oblique sliding bearing seats that are subject to radial loads and have a working environment temperature of -20~80℃. JB/T 2563-1991 Split-type four-stud oblique sliding bearing seat types and dimensions JB/T2563-1991 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
Split Four-Stud Oblique Sliding Bearing Seat
Type and Dimensions
Subject Content and Scope of Application
JB/T 2563-91
Replaces JB2563:79
This standard specifies the type and dimensions of split four-stud oblique sliding bearing seats and the selection requirements of bearing seats. This standard is applicable to split four-stud oblique sliding bearing seats that bear radial loads and have an operating environment temperature of -20 to 80°C. 2 Reference Standards
GB6403.4 Parts Rounding and Chamfering
JB/T2564 Technical Conditions for Sliding Bearing Seats
3 Type and Dimensions
The type and dimensions of the bearing seat shall comply with the provisions of Figure 1 and the following table. Figure 1
Approved by the Ministry of Machinery and Electronics Industry of the People's Republic of China on July 10, 1991394
Implemented on July 1, 1992
HX 070
HX 080
HX 090
HX 100
HX 110
HX 200
HX220220
2001240Www.bzxZ.net
200220
250270320
4 Requirements for the selection of bearing seats
JB/T 2563--91
4.1 The bearing is allowed to bear a small axial load through the shoulder. When the shoulder diameter is not less than the outer diameter of the bearing shoulder, the axial load allowed is not more than 30% of the maximum radial load. 4.2 The load direction of the bearing seat should be within 35° to the left and right of the bearing centerline perpendicular to the separation surface, as shown in Figure 2. The shaded part in the figure is the range of radial load allowed. Figure 2
4.3 The surface of the journal that matches the bearing seat should be hardened. 4.4 The size of the journal fillet should be selected according to GB6403.4. 5 Technical conditions
The technical conditions of the split four-stud oblique sliding bearing seat should comply with the provisions of JB/T2564. 395
6 Model and marking
Model description
6.2 Marking example
JB/T2563--91
Bearing inner diameter, nm
-Sliding bearing seat
d80mm split four-stud oblique sliding bearing seat: HX080 bearing seat JB/T2563
Additional instructions:
This standard was proposed and managed by the Xi'an Heavy Machinery Research Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted by the Second Heavy Machinery Plant. 396
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.