JB/T 2777-1992 PN16.0～32.0MPa non-porous lens pad
Basic Information
Standard ID:
JB/T 2777-1992
Standard Name: PN16.0～32.0MPa non-porous lens pad
Chinese Name:
PN16.0～32.0MPa无孔透镜垫
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1992-07-20
Date of Implementation:1993-01-01
standard classification number
Standard Classification Number:Machinery>>General Parts>>J16 Valve
associated standards
alternative situation:JB 2777-79
Publication information
publishing house:China Machinery Industry Press
Publication date:1993-01-01
other information
drafter:Huang Mingya, Wang Xiaojun
Drafting unit:Hefei General Machinery Research Institute, Ministry of Machinery and Electronics Industry
Focal point unit:Hefei General Machinery Research Institute, Ministry of Machinery and Electronics Industry
Proposing unit:Hefei General Machinery Research Institute, Ministry of Machinery and Electronics Industry
Publishing department:Ministry of Machinery and Electronics Industry of the People's Republic of China
Introduction to standards:
This standard specifies the type, size, and technical requirements of non-porous lens gaskets for forged high-pressure valves. This standard is applicable to non-porous lens gaskets with a nominal pressure of PN16.0 to 32.0 MPa and a nominal diameter of DN3 to 200 mm. JB/T 2777-1992 PN16.0 to 32.0 MPa non-porous lens gasket JB/T2777-1992 Standard download decompression password: www.bzxz.net
Some standard content:
Mechanical Industry Standard of the People's Republic of China
JB/T 277792
PN16.0～32.0MPa Non-porous lens pad
Published on July 20, 1992
Implementation on January 1, 1993 by the Ministry of Machinery and Electronics Industry of the People's Republic of China
Mechanical Industry Standard of the People's Republic of China
PN16.0~32.0MPu Non-porous lens pad
1 Main content and scope of application
The standard specifies the maximum suitable type, size, technical requirements, etc. of non-porous lens pads. JB/T2777-92
Replaces #2777-bZxz.net
This standard is applicable to the reference standard of non-porous lens pads with a nominal force of 1.0-32.0MPa and a diameter of 3~200mm
74·2.1 Absolutely new type! 3.1 The hole diameter m minus m shall comply with the following figure: 102777 3.2 The dimensions of the hole shall be as follows: The Ministry of Machinery and Electronics Industry approved it on July 20, 1992 and implemented it on January 1, 1993. The technical requirements are as follows: Nominal diameter JB/T 277792
52.5±0.9
The technical requirements and inspection rules of the aperture mirror pad shall be in accordance with the provisions of JB/T450. Additional remarks:
This standard is proposed by the General Machinery Research Institute of the Ministry of Machinery and Electronics Industry. This standard is under the responsibility of the General Machinery Research Institute of the Ministry of Machinery and Electronics Industry. The main drafters of this standard are Fei Mingya and Xiaojiang.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.