title>JB/T 7940.2-1995 Joint type pressure injection oil cup - JB/T 7940.2-1995 - Chinese standardNet - bzxz.net
Home > JB > JB/T 7940.2-1995 Joint type pressure injection oil cup
JB/T 7940.2-1995 Joint type pressure injection oil cup

Basic Information

Standard ID: JB/T 7940.2-1995

Standard Name: Joint type pressure injection oil cup

Chinese Name: 接头式压注油杯

Standard category:Machinery Industry Standard (JB)

state:in force

Date of Release1989-02-10

Date of Implementation:1990-01-01

standard classification number

Standard Classification Number:Machinery>>General Parts>>J21 Lubrication and Lubrication Devices

associated standards

alternative situation:Original standard number GB 1153-89

Procurement status:neq ISO B1575:1979

Publication information

other information

Focal point unit:Mechanical Standardization Institute

Introduction to standards:

JB/T 7940.2-1995 Joint type pressure injection oil cup JB/T7940.2-1995 standard download decompression password: www.bzxz.net

Some standard content:

Mechanical Industry Standard of the People's Republic of China
JB/T7940.2-1995
Joint-type grease injection cup
Angle hydraulic grease injection cup
1996-04-14 Issued
Ministry of Machinery Industry of the People's Republic of China
Implementation on 1996-04-14
Mechanical Industry Standard of the People's Republic of ChinawwW.bzxz.Net
Joint-type grease injection cup
Angle hydraulic grease injection cup
Subject Content and Scope of Application
This standard specifies the types and sizes of joint-type grease injection cups. This standard is applicable to grease injection cups for various mechanical equipment, automobiles, ships, etc. 2 Reference standards
GB1152 Straight-through pressure injection oil cup
GB1159 Technical conditions for oil cup
3 Types and dimensions
Types and dimensions are as specified in the following figure and table S R5.5
M10×1
Marking example
Connecting thread M10×1, 45 joint type pressure injection oil cup marking: Oil cup 45*M10×1GB1153
Approved by the Ministry of Machinery Industry on April 14, 1996
Basic dimensions
Limited deviation
JB/T7940.2—1995
On behalf of the police GB 1153—89
True-through type pressure-injected oil ring
(An GB1152)
Implementation on April 14, 1996
Technical conditions
Technical conditions shall be in accordance with the provisions of GB1159,
Additional notes:
This standard is proposed by the Ministry of Machinery and Electronics Industry: JB/T7940.2-—1995
This standard is under the jurisdiction of the Mechanical Standardization Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted at the expense of the Science and Technology Information Institute of Shanghai Mechanical and Electrical Industry Administration and the Mechanical Standardization Institute of the Ministry of Machinery and Electronics Industry, and was drafted with the participation of Shenyang Oil Cup Factory
The main drafters of this standard are Chen Huajin and Wang Xiliang.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.