GB 3752.2-1983 Compression fittings
Basic Information
Standard ID:
GB 3752.2-1983
Standard Name: Compression fittings
Chinese Name:
卡套式组合直角接头体
Standard category:National Standard (GB)
state:Abolished
Date of Release1983-06-17
Date of Implementation:1984-04-01
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:21.060.60;
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
publishing house:China Standards Press
Publication date:1984-04-01
other information
Release date:1983-06-17
Review date:2004-10-14
drafter:Hu Gesheng, Liu Dequan, Cheng Zhenshi, Wang Muqin
Drafting unit:Standardization Institute of the Ministry of Machinery Industry
Focal point unit:Standardization Institute of the Ministry of Machinery Industry
Proposing unit:Ministry of Machinery Industry of the People's Republic of China
Publishing department:National Bureau of Standards
competent authority:China Machinery Industry Federation
Introduction to standards:
GB 3752.2-1983 Compression sleeve type right angle joint body GB3752.2-1983 standard download decompression password: www.bzxz.net
Some standard content:
Marking example:
National Standard of the People's Republic of China
Compression fitting combination right angle joint body
A djus table elbow Body
Nominal pressure level I, compression fitting combination right angle joint body with outer diameter D of 14mm: Joint body J14GB3752.2—83
National Bureau of Standards 1983-06-17 Issued
UDC 621.648.4
GB3752.2-83
Others V
1984-04-01 Implementation
(Bar)
M10×1
M12×1.25
M27×1.5
M30×2
M33 ×3
M36×2
M42×2
M45×2
M48×2
M52×2
M30×2
M33×2
M36×2
M39 ×2
GB3752.2—83
Note: The weight is a calculated value, and the specific gravity is 7.85kg/dm. The technical conditions shall comply with the provisions of GB3765—83. Limit
GB 3752.283
(kg/100 pieces)www.bzxz.net
G8 12-3
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and drafted by the Standardization Research Institute of the Ministry of Machinery Industry. The heavy machinery, heavy automobile research institute, Yamato bed research institute, Shanghai No. 1 Bureau of Science and Technology of Shanghai Municipality, Ministry of Aerospace and other drafters participated in the drafting of the standard. The main drafters include Gu Zhisheng, Liu Dequan, Cheng Hou, and Wang Shijia. From the implementation of this standard, the original standard B1 card set combination direct free body is drafted
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.