Determination of loss on ignition in high purity arenaceous quartz
Basic Information
Standard ID:
SJ 3228.3-1989
Standard Name:Determination of loss on ignition in high purity arenaceous quartz
Chinese Name:
高纯石英砂灼烧失量的测定
Standard category:Electronic Industry Standard (SJ)
state:Abolished
Date of Release1989-03-20
Date of Implementation:1989-03-25
Date of Expiration:2016-06-01
standard classification number
Standard Classification Number:General>>Standardization Management and General Provisions>>A01 Technical Management
Publication information
Publication date:1989-03-25
other information
drafter:Sheng Jianguo, Qin Guozhen
Drafting unit:The 18th Research Institute of the Ministry of Machinery and Electronics Industry
Proposing unit:Electronic Standardization Institute of the Ministry of Machinery and Electronics Industry
Publishing department:Ministry of Machinery and Electronics Industry of the People's Republic of China
Introduction to standards:
This standard specifies the determination of ignition loss of high-purity quartz sand. This standard is applicable to various grades of high-purity quartz sand. SJ 3228.3-1989 Determination of ignition loss of high-purity quartz sand SJ3228.3-1989 Standard download decompression password: www.bzxz.net
This standard specifies the determination of ignition loss of high-purity quartz sand.
This standard is applicable to various grades of high-purity quartz sand.
Some standard content:
Standard of the Ministry of Machinery and Electronics Industry of the People's Republic of China Determination of Ignition Loss of High Purity Quartz Sand
1 Subject Content and Scope of Application
1.1 Subject Content
This standard specifies the determination of ignition loss of high purity quartz sand. 1.2 Scope of Application
This standard applies to various grades of high purity quartz sand. 2 Method Summary
SJ3228.3—B9
The adsorbed water, carbonates, organic matter and other volatile substances contained in the sample will decompose and volatilize after high temperature ignition. The amount lost by ignition is the ignition loss. 3 Analysis Steps
Accurately weigh 1g of the sample, place it in a constant platinum glass, cover it and place it in a 9501000℃ muffle furnace to ignite for 1h, transfer it to a desiccator and cool it to room temperature before weighing it. Ignite for 20min, cool and weigh it, and repeat the ignition until constant.
4 CalculationbZxz.net
Ignition loss (%) = m1 = m = x × 100
Wherein: m1——Platinum and sample weight before ignition. g, m2——Platinum crucible and sample weight after ignition. g
m-Sample weight. g.
Additional notes:
This standard was proposed by the Electronic Standardization Research Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted by Hubei Guangshui Quartz Powder Factory and the 18th Research Institute of the Ministry of Machinery and Electronics Industry. The main drafters of this standard: Sheng Jianguo and Qin Guozhen. Approved by the Ministry of Machinery and Electronics Industry of the People's Republic of China on March 20, 1989 and implemented on March 25, 1989
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.