SJ/T 10552-1994 Emission spectral analysis method for impurities in titanium dioxide for electronic ceramics SJ/T10552-1994 standard download decompression password: www.bzxz.net

Electronic Industry Standard of the People's Republic of China
SJ/T10551~10553-—94
Methud of. emisson spectrochemical analysis of impurities inAl,Or,TiO, and ZrO, far zse jn elerlron eramics1994-08-68Published
1994-72-01Implementation
The Ministry of Electronics Industry of the People's Republic of ChinaPublished the Electronic Industry Standard of the People's Republic of China
Methud of. emisson spectrochemical analysis of impurities inAl,Or,TiO, and ZrO, far zse jn elerlron eramics1994-08-68Published
1994-72-01Implementation
The Ministry of Electronics Industry of the People's Republic of ChinaPublished the Electronic Industry Standard of the People's Republic of China
Methud ofmissioul sprethorhemical anlyaig nf iraparitlerJnTin,fnrusein clectron 1 Subject and scope of application 1.1: This standard specifies the emission light analysis method for titanium dioxide used in electronic ceramics 1.2 Scope of application ST/10552-94 This standard is only applicable to the determination of the total amount of silicon, calcium, magnesium and sulfide contained in titanium dioxide used in electronic ceramics. 2 Method summary The standard sample is mixed with titanium dioxide grade precipitate in the following proportions: 2: Mix the sample with titanium dioxide precipitate: 0.1% chromium, In,O, 0.1% G43%, Kel2%, Nal 2,[CO,%, Arl,HF: 37, %, right net powder 51.1%,
with phosphorus as internal standard, language as internal standard, test and other elements in the case of relaxation, bypass the impact of the matrix and the third party, so that phosphorus pentoxide aluminum trioxide and other analysis of the micro-improvement, so the test work and the standard of the spectrum of the material can be used on a optical plate to determine the impurity content of the plate by the internal standard method. 3 reagents or materials
two loaded north two pot
new oxide family
blue silicon oxide
de phosphoric acid money
monochromic acid
two loaded chemical
two loaded chemical
oxygen letter two clamp
resign from the edge
chloride imperialbZxz.net
analysis classic;
analysis absolute!
analysis pure,
analysis new practice;
analysis dye!
Spectral line:
Guzhou pure,
Analytical pure:
Analytical system:
Ministry of Electronic Industry of the People's Republic of China approved on 14-12-01, 199408·08 implementation
Sodium sulphide
Carbon dioxide
Huangbei smelting
Sulphide lock
Five toner
Optical board
Separation pure,
Analytical pure;
Analytical pure!
Analytical grade:
Photosensitive material
Product I:
Sj/r1D552-94
Methol-Hydroxyfluorescein solution and fixing drops (prepared according to the recipe in the photosensitive cabinet instruction manual): graphite electrode
Receiver or equipment
5 sample
mid-range spectrum
current generator:
microphotometer
word only,
analytical technique
instrument research chain:
autumn attack;
spectral range +6mm.
Sensitivity 0g:
Make a stone whole electrode on a small lathe,
5. tPreparation of standard sample
Synthesize silver trioxide and each oxide to be tested at 900℃, bake at 159℃ for 2h, according to the calculated amount, add each impurity compound and salt into the secondary chemical to prepare the main standard sample, and then add them one by one in the secondary chemical to prepare a gold standard sample, its name is 1.
·Monthly standard sample
No. 2 standard sample
Sanyue standard sample
Xixue Jing sample
Wuhan standard sample
Eighth academic standard file
5.2 Product handling list
SIT 10552 94
Products that have not been calcined at high temperature must be collected. After calcining for 2,6 steps
6.1 Standard sample and sample are respectively ground with 10:2 ratio in the code book grinder, and then put into the lower hole. Fill it and bake it for about 200 degrees for 2 hours, and then take it immediately. The shape of the electrode is shown in the figure below, 46. 0
On the phone
Off the camera
62 uses a lens illumination system, uses a step dimming rate of 100% and 10% two steps, white current cathode invites, voltage 300V, current intensity 13.6=0A, gap width 13um+electrode distance 2=0.9mrn, shading 5mm, sleep 3s, each sample is photographed 3 times, the plastic photosensitive plate is developed in a Mil-sea pipeline developer, the wavelength above 350um should be developed for 3me, the wavelength below R59am should be developed for 4min, the temperature is 18~20, the film fixing water is micro, the probe, the calculation of the analysis result
car micrometer is the meter. The black of the quantitative folding line is used to make a S(PO) curve with S or g. The impurity content of the sample is found out by the working line: the folding line extension wavelength and the measurement situation 2. Table 2
Line length
Measured composition
Xinyuandong
Si298.158
Mg272.55s
AI309-27E
Sh239-8
Comparison Kangsu
1i30t.7,9
T1396.427
Th284.194
ni308.940
Ax249 29.
Grs239.234
Routine meeting model E
C.01--0.02
c.c2~.n.+n
C.61~.0. 2n
c.c1--f.2n
C.t1~0.4n
n: 025~-0. 46
C.<-1 . 2n
Precision or tolerance
5.1/10552 -94
%0.2%40, and S000%0, and M00.%
An Dioxygen is naturally determined according to this resolution 21 negative, the measured standard deviation is within the listed effectiveness of the previous 1, the fixed place
North standard technology belt
8.2 confirmation
When the record shore trial approval sweep conclusion right draft center, the standard class change capital complaint special rate, additional notes:
This standard is produced by the heart (industry often show Hao than research institute mouth. This standard is mainly produced by the industry strong standard special ratio research institute Wu drafted, Mgo
4 standard respected drafter! Shi Yubian Cheng Yue Shao Chang, main show Wen Li Guoqi.8
Sheths
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.