HG/T 2256-1991 Determination of ash content of photographic chemicals HG/T2256-1991 standard download decompression password: www.bzxz.net

Chemical Industry Standard of the People's Republic of China
Determination of ash content of color formers
Photographic chemicals
Subject content and scope of application
This standard specifies the determination method of ash content of color formers. This standard is applicable to color formers used in the production of color films, color films and color photographic papers. 2 Method Summary
The sample is carbonized and burned at low temperature to constant weight. 3 Instruments or equipment
3.1 High temperature protection: 800±50℃,
3.2 Balance: sensitivity is 0.1mg.
3.3 Earth: 50~100mL porcelain crucible
3.4 ​​Dryer: filled with color-changing silica gel or anhydrous calcium chloride. 4 Determination method
HG2256-91
Weigh 1g of sample, accurate to 0.01g, place in a crucible with constant weight, and slowly heat on an electric furnace in a fume hood. After the sample is completely carbonized, move it into a high-temperature furnace and burn it at 800±50℃ to constant weight (about 4h). The difference between two consecutive results at constant weight is no more than 0.0004g.
5 Calculation of determination results
The mass percentage X of ash is calculated as follows: X
Where: m
-the mass of the crucible plus the residue, g;bZxz.net
m2-the mass of the crucible, g;
mthe mass of the sample, g.
Parallel determination was performed three times, and the range should not be greater than ±0.04%. The results were averaged. Approved by the Ministry of Chemical Industry of the People's Republic of China on December 28, 199110
The standard was approved by mm.b2eoeo.ctm and implemented on July 1, 1992
Additional notes:
HG225691
This standard was proposed by the Science and Technology Department of the Ministry of Chemical Industry of the People's Republic of China. This standard is under the jurisdiction of the Photographic Chemicals Standardization Technical Unit of the Ministry of Chemical Industry, and this standard was drafted by Qingdao Dye Factory. The Photosensitive Materials Technology Development Center of the Ministry of Chemical Industry participated in the drafting. The main drafters of this standard were Hu Jialin, Zhuang Youqin, Wen Huiqiong, and Hu Suqin. The standard was approved by m.bsoso.cn and various standards industry resources were downloaded for free11
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.