JB/T 9158.10-1999 Dimensions of cutting tool holder for horizontal multi-spindle automatic lathe
Basic Information
Standard ID:
JB/T 9158.10-1999
Standard Name: Dimensions of cutting tool holder for horizontal multi-spindle automatic lathe
Chinese Name:
卧式多轴自动车床辅具 切断反刀夹尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Machine Tools>>25.080.10 Lathe
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Introduction to standards:
JB/T 9158.10-1999 JB/T 9158.10-1999 Horizontal multi-spindle automatic lathe auxiliary tool cutting reverse clamp dimensions JB/T9158.10-1999 Standard download decompression password: www.bzxz.net
Some standard content:
1CS 25.080.01
Machinery Industry Standard of the People's Republic of China
JB/T9158.1~9158.13—1999
Accessories of multi-spindle horizuntal automatic lathes
Accessories of multi-spindle horizuntal automatic lathes1999-05-20 Issued
National Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Accessories of miti-apindie horiznntal automatle lathesReveraalpostforcut-orf-DimensinngThis standard specifies the types and sizes of cutting tools for horizontal multi-spindle automatic lathes. 2 Cited standardswww.bzxz.net
JB/T9158.10—1999
Generation 7.H/T152012.10—90
The provisions contained in the following standards constitute the provisions of this standard through reference in the water standard. When this standard is published, the versions shown are valid. All standards are subject to revision. Parties using non-standards should explore the possibility of using the latest versions of the following standards: GR No. 15R1996 Machine Tools 1. T-shaped bolts and corresponding bolt types and sizes
Types and sizes are as shown in the following figure and table. Approved by the National Machinery Industry Bureau on 1999-0S-20 and implemented on 2000-01-01
4 Building record
Marking example:
Body size
Limit deviation
180158.10-194
F-55mm, 3mm cutting reverse knife fire mark 30
Reverse fire 55×39158.10—1999
Applicable to A machine definition
C2132.611
.2161.6
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.