JB/T 9190-1999 JB/T 9190-1999 Clutch Friction Plate Dimensions JB/T9190-1999 Standard download decompression password: www.bzxz.net

JB/T 9190-—1999
This standard is a revision of ZBJ19028-90 "Clutch Friction Plate Dimensions". During the revision, the original standard was edited, and the main technical content remained unchanged.
This standard replaces 2BJ1902890 from the date of implementation.
This standard was proposed and assigned by the National Technical Committee for Standardization of Metallic and Non-metallic Coatings. The drafting unit of this standard: Wuhan Institute of Material Protection. The main drafters of this standard: Chen Hefa, Yao Huajun, Zhang Cheng. 152
1 Scope
Machinery Industry Standard of the People's Republic of China
Size of friction face sheets for clutch
Size of friction face sheets for clutchThis standard specifies the size series of friction face sheets for clutch, JB/T9190--1999
Replaces ZBJ19028:90
This standard applies to mechanical friction clutch face sheets (hereinafter referred to as clutch face sheets) of various automobiles, tractors, engineering machinery and gearboxes. The geometric shape of clutch face sheets is an overall circular ring, and other shapes of face sheets are not applicable to this standard. This standard does not involve the surface structure type of friction face sheets.
2 Size series of friction face sheets for clutch
The size series of dry clutch face sheets is shown in Figure 1 and Table 1. The size series of wet clutch face sheets is shown in Figure 2 and Table 2. The tooth profile of wet clutch face sheets is an involute tooth profile. Figure 1
Dry clutch facing
Figure 2 Hybrid clutch facing
Approved by the State Machinery Industry Bureau on 1999-06-28 and implemented on 2000-01-01
Outer diameter D
280(279)
Inner diameter d
110(76)
110,120
130,140
150,160
150,155.160
165-180||t t||175.180,190
190.200.210
195,200,210
200,220.240
235.240.250
240,250
265,290
JB/T9190--1999
Dry clutch facing
Limit deviation
Note: The dimensions in brackets are only applicable to a few types of clutch facings originally produced. Inner diameter
Table 2 Wet clutch facingwwW.bzxz.Net
Inner diameter D2
40,45,55
100(105)
(92)(95)
Thickness H
Modulus m
Thickness difference of each plate
Pressure angle
(30°）
Outer diameter D
（255）
Inner diameter Dz
92,100,112
136,140
165,200
235,245.254
298,300
320,340
（325）
JB/T9190—1999
Continued Table 2
Module m
Pressure angle
(30°)
Outer diameter D
Inner diameter D
JB/T9190—1999
Continued Table 2
Note: The dimensions in brackets are only applicable to a few types of clutch facing plates originally produced. 156
Pressure angle
（30°)
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.