GB/T 5634.1-1985 Flared combined right angle tee pipe joint
Basic Information
Standard ID:
GB/T 5634.1-1985
Standard Name: Flared combined right angle tee pipe joint
Chinese Name:
扩口式组合直角三通管接头
Standard category:National Standard (GB)
state:Abolished
Date of Release1985-01-01
Date of Implementation:1986-09-01
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:Fluid systems and general parts>>Pipeline components and pipelines>>23.040.60 Flanges, pipe joints and connecting parts
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
other information
Release date:1985-11-25
Review date:2004-10-14
Drafting unit:Standardization Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Standardization of Pipe Accessories
Publishing department:China Machinery Industry Federation
competent authority:China Machinery Industry Federation
Introduction to standards:
GB/T 5634.1-1985 Flared combined right angle tee pipe joint GB/T5634.1-1985 standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Flared type tube fittings-
Swivel rum tee-Assembly
This standard applies to flared type tube fittings for use in piping systems with oil and gas as the medium. GB 5634.2 —1
GH 5647-
GB 5646—85
Marking example:
Expanded combined right angle tee pipe joint with pipe outer diameter Dr of 10 mm: Pipe joint 10GB5634.1—85
National Bureau of Standards1985-11-25Promulgated
UDC621.643.4
GB 5634. 1
1986-09-01ImplementationWww.bzxZ.net
Sub-outer diameter
M10 × 1
M12 ×1.5
M14× 1.5
M18 ×1, 5
M22 × 1. 5
M24 × 1. 5
M27 × 1. 5
M30×2
M33×2
M36×2
M39×
M42 × 2
M45 × 2
GB 5634.185
62.51 60.5
57.7 4 57.7
Mass (steel)
kg/100 pieces
Note: The opposite side dimension is S. The structure of the locking nut and its connection method with the fitting body are determined by the manufacturer! However, the dimensions shown in the figure shall comply with the provisions of the above table, and the nut shall be able to rotate freely on the fitting body. The technical conditions shall be in accordance with the provisions of GR5653-85 "Technical Conditions for Expanded Pipe Fittings". Additional Notes:
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and is under the jurisdiction of the Standardization Research Institute of the Ministry of Machinery Industry. This standard was drafted by the Standardization Research Institute of the Ministry of Machinery Industry, Shanghai Hydraulic Accessories!, Changyang Automobile Research Institute, and Shanghai Hydraulic and Pneumatic Research Institute.
The main drafters of this standard are Hu Lusheng, Li Ningning, and Zhang Qianlong.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.