This standard specifies the basic parameters and installation dimensions, markings and technical requirements for quick-release rings for machine tool exchange gear shaft ends. This standard applies to machine tool exchange gear shaft end fixation. Other mechanical exchange gear shaft end fixation can also be used as a reference. JB/T 8598-1997 Quick-release rings for machine tool exchange gear shaft ends JB/T8598-1997 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
IB/T 8598-1997
Machine Tool Exchange Gear Shaft End Fixed Quick Release Ring
1997-08-18 Issued
The Ministry of Machinery Industry of the People's Republic of China
1998-01-(1 Implementation
JR/T8598-1997www.bzxz.net
This standard is issued by the National Bureau of Cutting Machine Tool Standardization Technical Committee. This standard is issued by the Ministry of Industry and Information Technology of the People's Republic of China. The Ministry of Industry and Information Technology of the People's Republic of China. The Ministry of Industry and Information Technology of the People's Republic of China. The Ministry of Industry and Information Technology of the People's Republic of China. The Ministry of Industry and Information Technology of the People's Republic of China. National Machinery Industry Standard
Machine Tool Exchange Gear Shaft End Fixed Quick Release Ring
JB/T85981997
This standard specifies the technical parameters and dimensions of the exchange gear shaft end of the machine tool. The new technical requirements require the standard to be used for the exchange gear shaft end of the machine tool. The machine tool exchange gear shaft end is fixed and used. 2 Reference standards
The following are the full text of the standard. The referenced articles in the standard are the provisions of this standard. This standard is called the standard. It is valid for a period of time. It has the possibility of being used by the industry or the standard for the most likely use. G 1!-
GR 1801-79
GB 3597 88
Eliminate machine pin
Tolerance! Fitting scale to 5>mm hole, single public band and matching deep dynamic bearing packaging
Basic chips and installation dimensions
This set of teaching and installation scale Figure 1 Figure 2 and Table 1,
Ministry of Machinery Industry 1518 into
199801 implementation
Car mark
JBT AS98
c Gs-t
Inner hole diameter = 21m machine tool material quality wheel shaft end area determination quick control letter: 20JB/85981997
5 Technical requirements
The quality, processing quality, surface treatment and other aspects of the parts should comply with the product drawings and relevant technical documents. 5.2 Parts matching tolerance connection G101. Quick release inner hole calibration H7, with its matching shaft, extreme 17E.3 Product frequency protection and packaging should comply with G3859. 5, 4 Assembly and opening and re-opening of the road wheel should be flexible and reliable. mY
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.