GB/T 5631.1-1985 Flared adjustable end right angle pipe joint
Basic Information
Standard ID:
GB/T 5631.1-1985
Standard Name: Flared adjustable end right angle pipe joint
Chinese Name:
扩口式可调向端直角管接头
Standard category:National Standard (GB)
state:Abolished
Date of Release1985-01-01
Date of Implementation:1986-09-01
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:Fluid systems and general parts>>Pipeline components and pipelines>>23.040.60 Flanges, pipe joints and connecting parts
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
publishing house:China Standards Press
Publication date:1986-09-01
other information
Release date:1985-11-25
Review date:2004-10-14
Drafting unit:Standardization Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Standardization of Pipe Accessories
Publishing department:National Bureau of Standards
competent authority:China Machinery Industry Federation
Introduction to standards:
This standard applies to flared adjustable end right angle pipe joints for pipeline systems with oil and gas as the medium. GB/T 5631.1-1985 Flared adjustable end right angle pipe joints GB/T5631.1-1985 Standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Flared type tube fittings-
Straight thread elbow -AssemblyThis standard applies to flared type tube fittings with adjustable ends for use in piping systems with oil and gas as the medium. GB.5646—85
GH 5647bzxz.net
GE5631.2-
GB 5649—85
GR 5852-
Marking example:
Flared adjustable right-angle pipe joint with outer diameter of 10 mm: Pipe joint 10 GB 5631.1—85
National Bureau of Standards 1985-11-25 Issued
UDC B21.643.4
GB 5631. 185
1986-09-01 Implementation
Outer diameter
M10×!
Mt2 × 1. 5
M 16 x 1. 5
M18 × 1.5
M27×2
M33 × 2
M42 × 2
GB5631.1-85
31.2134.6
Technical conditions shall be in accordance with the provisions of GB.5653-85 "Technical conditions for flared pipe joints". Additional remarks:
Quality Kun (steel)
kg/1aoft:cm
This standard is proposed by the Ministry of Machinery Industry of the People's Republic of China and is under the jurisdiction of the Standardization Research Institute of the Ministry of Machinery Industry. This standard was drafted by the Standardization Research Institute of the Ministry of Machinery Industry, Shanghai Liquid Card Accessory Factory, Changchun Automobile Research Institute, and Shanghai Hydraulic and Pneumatic Research Institute.
The main contributors to this standard are Hu Lusheng, Li Ningning, and Zhang Qianlong. From the date of implementation of this standard, the original Ministry standard JB1908-77 "Flared end right angle pipe joint" shall be invalid.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.