HG/T 2129.23-1991 Acid-resistant phenolic plastics for chemical equipment parts Flange type right angle reducing cross HG/T2129.23-1991 Standard download decompression password: www.bzxz.net

Scope of application
Chemical Industry Standard of the People's Republic of China
Flanged right-angle reducing cross made of acid-resistant phenolic plastic chemical equipment parts
HG/T2129.23-91
This standard applies to flanged right-angle reducing cross made of acid-resistant phenolic plastic with an allowable temperature of -30℃～130℃ and an allowable pressure as specified in the table below.
Cited Standard
HG/T2128 Technical Conditions for Chemical Equipment, Pipes and Fittings Made of Acid-resistant Phenolic Plastic 3 Type and Basic Dimensions
Type and basic dimensions are as specified in the figure and table below, enlarged view of part A
Unspecified corner r>3mm
Approved by the Ministry of Chemical Industry of the People's Republic of China on August 19, 1991 and implemented on January 1, 1992 Shi
Nominal diameter
DN/D'M
100/80
150/100
200/150
250/200
300/250
350/300
400/350
450/ 400
500/45 0
128/94
148/128
206/148
256/206
320/256Www.bzxZ.net
370/320
430/370
480/430
533/480||tt| |590/538
HG /T2129.23—91
Quality inspection, packaging, storage and transportation of raw materials and products t/g'
-12/10
Quality inspection, packaging, storage and transportation of raw materials and products shall comply with the provisions of HG/T2128, 3
Marking example
Allowable pressure at room temperature
MPa(kgt/cm2)
0.15 (1.5)
0.13 (1.3)
The flanged right-angle reducing cross made of acid-resistant phenolic plastic with nominal diameter DN=50mm and DN=32mm is marked as: Cross DN50/32HG/T2129.23--91
6 Selection instructions
Right-angle reducing crosses outside the standard series can be resolved through negotiation between the supply and demand parties and this standard number can still be used. For example: The flanged right-angle reducing cross made of acid-resistant phenolic plastic with nominal diameter DN=00mm and DN=100mm is marked as:
Cross DN300/100HG/T2129.23-91
Additional instructions:
This standard was proposed by China National Chemical Equipment Corporation and is under the jurisdiction of the National Technical Committee for Standardization of Non-metallic Chemical Equipment. This standard was drafted by Chengdu Chemical Research and Design Institute and the main drafters of this standard were He Jiabing and He Jin. 50
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.