JB/T 8004.6-1999 Machine tool fixture parts and components diamond nuts
Basic Information
Standard ID:
JB/T 8004.6-1999
Standard Name: Machine tool fixture parts and components diamond nuts
Chinese Name:
机床夹具零件及部件 菱形螺母
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 8004.6-1999 This standard is a revision of JB/T 8004.6-95 "Rhombus nuts for machine tool fixture parts and components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies rhombus nuts with ordinary thread specifications of M4 to M16. This standard was first issued in 1981 as GB 2153-80, first revised to GB/T 2153-91 on April 30, 1991, and adjusted to JB/T 8004.6-95 in April 1996. JB/T 8004.6-1999 Rhombus nuts for machine tool fixture parts and components JB/T8004.6-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of ChinabzxZ.net
Parts and units of jigs and fixtures
Rhombic nut
This standard specifies rhombic nuts with thread specifications of M4~M16. 2 Referenced standards
JB/T8004.6—1999
Replaces JB/T8004.6—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T699-1988
Technical conditions for high-quality carbon structural steel
JB/T8044-1999Technical requirements for machine tool clamps and their parts and components3 Dimensions
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999 and implemented on January 1, 2000
4 Technical conditions
4.1 Material: 45 steel in accordance with the provisions of GB/T699. 4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions shall be in accordance with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
d-M10 diamond nut:
M10JB/T8004.6—1999
JB/T 8004.6—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.