JB/T 10118-1999 Heart-shaped chucks for machine tool fixture parts and components
Basic Information
Standard ID:
JB/T 10118-1999
Standard Name: Heart-shaped chucks for machine tool fixture parts and components
Chinese Name:
机床夹具零件及部件 鸡心卡头
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-08-06
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)
Standard Classification Number:Machinery>>Process Equipment>>J44 General Fixture
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 10118-1999 This standard specifies the heart-shaped chucks for workpieces with a diameter of 3 to 130 mm. This standard was first issued in 1983 as JB 3392-83 and revised for the second time in 1991 as GB/T 12883-91. JB/T 10118-1999 Heart-shaped chucks for machine tool fixture parts and components JB/T10118-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC5 28.060.41
Mechanical Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
1Model
Mechanical Industry Standard of the People's Republic of China
Machine tool parts and components
Peach slaped pawl
The parts and units nf jigy and fixturesPeach slaped pawlbzxz.net
This standard specifies the dimensions of the heart chuck 2 suitable for upper parts with a diameter of 3-13mm
The dimensions are shown in the following figure and table.
Guosuo Machinery Industry approved 306 on August 6, 1999
JB101-9
2000-01-01 implementation
Nominal diameter
(recent information 1 bucket diameter)
>6- 12
>12 - 18
>18 - 25
>25-35
>15 -50
>50 - 65
>100 -130
3 Marking
3.1 Marking example:
JB/T10118-1999
Nominal diameter 12.-18m type chicken heart head: clamp head A12-1RJET[0118—1909
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.