title>Methods of determination for viscosity of potassium silicate solution for use in electronic industry - SJ/T 10227-1991 - Chinese standardNet - bzxz.net
Home > SJ > Methods of determination for viscosity of potassium silicate solution for use in electronic industry
Methods of determination for viscosity of potassium silicate solution for use in electronic industry

Basic Information

Standard ID: SJ/T 10227-1991

Standard Name:Methods of determination for viscosity of potassium silicate solution for use in electronic industry

Chinese Name: 电子工业用硅酸钾溶液粘度的测定方法

Standard category:Electronic Industry Standard (SJ)

state:in force

Date of Release1991-05-28

Date of Implementation:1991-12-01

standard classification number

Standard Classification Number:General>>Standardization Management and General Provisions>>A01 Technical Management

associated standards

Publication information

other information

Introduction to standards:

SJ/T 10227-1991 Determination of viscosity of potassium silicate solution for electronic industry SJ/T10227-1991 Standard download decompression password: www.bzxz.net



Some standard content:

Electronic Industry Standard of the People's Republic of China SJ/T 10226~10227 ---91
Potassium silicate solution for electronics industry
Determination method of density and viscosity
Published on 1991-05-28
Implemented on 1991-17-01
Published by the Ministry of Machinery and Electronics Industry of the People's Republic of China
Electronic Industry Standard of the People's Republic of China Determination method of viscosity of potassium silicate solution for electronics industry Potassium silicate solution for electronics industry-the methods of deiermination to viscosity【Main content and scope of application】This standard specifies the determination method of liquid density, but is not applicable to the determination of viscosity of silicate solution for electronics industry. PrinciplebZxz.net
SJ/T 10227—97
The resistance to the potential applied in the threading liquid is proportional to the torsion of the spring of the meter when the rotation is about the same as the rotation. This meter indicates the effectiveness of the instrument. The 3-axis meter
2. 1 is in the rotation type meter. The actual value of
5.3 is 6. ℃,
4 Determination step
will be the grinding acid wave, for example, into the mutual diameter of "70n" will be in the case of the need for the group of instruments in the constant loss device. The heart number turned the table car right connection, through the full, let the liquid and the rotor wave surface mark machine, the box liquid extreme control at 2 =. Work, turn the visual, select the turn Di hair 3/, open the electric hole to identify the turn in the prisoner can turn 2, install the indicator dig rod, turn off the motor, then the wrong needle stopped at the dense, read the agricultural not less than three 5 internal sensitivity value, liquid its level letter inquiry. 5th
In the formula?||tt| |Station, Pa·);
Female system effect;
The measured values ​​are average values,
Ministry of Machinery and Electronics Industry of the People's Republic of China 19910528 Approved 1991-12-01 Field
Additional remarks:
SJT1022791
This standard is issued by the Ministry of Machinery and Electronics Industry of the People's Republic of China. This standard was drafted by the 741 Factory Joint Chemical Industry! and the Electronic Standardization Research Institute of the Ministry of Machinery and Electronics Industry. The main drafters of this standard are Zhan Xuemu, Zhi Yuyun,
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.