JB/T 3411.9-1999 45° round inner hole turning tool bar dimensions
Basic Information
Standard ID:
JB/T 3411.9-1999
Standard Name: 45° round inner hole turning tool bar dimensions
Chinese Name:
45°车内孔圆刀杆 尺寸
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-05-20
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Mechanical Manufacturing>>Machine Tools>>25.080.01 General Machine Tools
Standard Classification Number:Machinery>>Metal Cutting Machine Tools>>J52 Machine Tool Accessories and Accessories
Publication information
other information
Focal point unit:Mechanical Science Research Institute
Publishing department:Mechanical Science Research Institute
Introduction to standards:
JB/T 3411.9-1999 This standard is a revision of JB 3419-83 "Dimensions of 45° internal hole turning round cutter bar". Only the following points were modified during the revision, and the main technical content remained unchanged. ——Writing format; ——Standard plus English name; ——Related reference standards and related content; ——Thread drawing method. This standard specifies the type and size of 45° internal hole turning round cutter bar. JB/T 3411.9-1999 Dimensions of 45° internal hole turning round cutter bar JB/T3411.9-1999 Standard download decompression password: www.bzxz.net
Some standard content:
[CS25.080.01bzxz.net
Machinery Industry Standard of the People's Republic of China
JB/T 3411.1-3411.16—1999
Accessories ofgeneral purpose parallel lathes1999-05-20Promulgated
National Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Dimensions of tool holder for 45' internal turning-TimensionsThis standard specifies the type and size of tool holder for internal turning-timensions. 2 Type and size
The type and size shall be as specified in the following figure and table.
JB/T 34J1.9-1999
generation 3415-83
12 160 200 160 200 250|200|250|313 250|315 400|250|315400 3154400 5014400 500 630
Limited maintenance
Note: (>20mn, the knife square hole needs to be made into an effective surface shape. Marking
Marking example:
-16mm, L=160mm 45° annual hole network Wantuo: knife bar 16×160JB door 3411.9--1999
Figure Home Machinery Industry Bureau 1999-05-20 approved 12
2000-01-01 implementation
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.