This standard specifies the pre-adjustment test, geometric accuracy and working accuracy requirements and test methods for lightweight cantilever planers and gantry planers. This standard applies to lightweight cantilever planers and gantry planers for general use with a maximum planing width of 800~1250mm. JB/T 8333.1-1996 Lightweight cantilever planers and gantry planers Accuracy JB/T8333.1-1996 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
JB/T 8333.196
Lightweight cantilever planer, planer
1996-04-11 Issued
Chenghua Ministry of Machinery Industry of the People's Republic of China
1996-10-01 Implementation
Mechanical Industry Standard of the People's Republic of China
Lightweight base planer, planer
1 Question Content and Scope of Application
JB/T 8333. 196
This standard specifies the requirements and inspection methods for the pre-adjustment inspection, working accuracy of portable cutting machines and planers. This standard is applicable to portable cutting machines with a width of 8C to 1250mm and gantry cutting machines. 2 Reference standards
J82570 General rules for inspection of metal cutting machines
3 General requirements
3. [Refer to Article 3.1 of JB2670 to adjust the level of the machine. Place a water level gauge at both ends of the bed in the longitudinal and transverse directions. The reading in the horizontal direction should not exceed 0.040/1010. 3.2 During the inspection, the actual inspection order shall be arranged according to the inspection tools and inspection force of the standard. 3.3 During the working precision inspection, the test piece shall be inspected on the precision planer. 3.4 Ring adjustment inspection will inspect 01GC2.GC3 during assembly, and no re-inspection will be done after load test. 3.5 When the actual measured length is different from the length specified in this standard, the tolerance will be converted according to the length of the measuring plate specified in 2.3.1.1 of J12670. When the conversion result is less than 0.005 mm, it will still be calculated as 0.005 mm. 3. The force direction parallel to the bed rail is called the longitudinal direction, and the horizontal direction perpendicular to the weaving direction is called the loss direction. Approved by the Ministry of Machinery Industry on April 11, 1996
Implemented on October 1, 1996
JB/T8333.196
''29'3*+1'
00000000
D08000
JD/T 8333:I6
1os0\0
000008
C008--000 42
/T 8333, 1-96 | | tt | ||JB/T 8333. 1-96
Shu Shoushe
00E/U0*0
Huwei Huabi
833,1-96
Ban/TE
821'fs[7
0009~000
0000002
wsgusls
14 a 0yipst 2
JB/T 8343: 1 96www.bzxz.net
z't't'g'git'?
Junmin ruler
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.