JB/T 2001.13-1999 Types and dimensions of square flanges for water systems (PN=4.0MPa)
Basic Information
Standard ID:
JB/T 2001.13-1999
Standard Name: Types and dimensions of square flanges for water systems (PN=4.0MPa)
Chinese Name:
水系统 方附接法兰 型式与尺寸(PN=4.0MPa)
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1999-06-28
Date of Implementation:2000-01-01
standard classification number
Standard ICS number:Fluid systems and general parts >> 23.100 Fluid power systems
Standard Classification Number:Machinery>>General Parts>>J20 Hydraulic and Pneumatic Devices
Publication information
other information
Focal point unit:Metallurgical Equipment Standardization Technical Committee
Introduction to standards:
JB/T 2001.13-1999 JB/T 2001.13-1999 Types and dimensions of square flanges for water systems (PN=4.0MPa) JB/T2001.13-1999 Standard download decompression password: www.bzxz.net
Some standard content:
IC.s$ 23.110
Standard of the Machinery Industry of the People's Republic of China
JB/T 2001.1~2001.74—1999www.bzxz.net
Water system assembly and parts1999-06-28 Issued
National Bureau of Machinery Industry
2(-01-U1 Implementation
Standard of the Machinery Industry of the People's Republic of China
Water system square attached flange
Type and size
Water systeni-Nsquare attached flangeType and stzr
( PN-4.0 MPa 1
This standard specifies the type and size of square flanges. This standard specifies the nominal pressure of the fluid in the system. 4. The pressure is not a system pressure of MPa. 3 Reference standards
JR/T2001.13—1999
The clauses contained in this standard are referenced in this standard and constitute the clauses of the blank standard. When this standard is published, all versions are valid. All standards are subject to revision. All parties using this standard should consider using the latest version of the following standards. JR T201.5199 Type and size of flanges for water systems 3 Type and size
3.1 The type shall be in accordance with the provisions of Figure 1.
Screw: 2-nut:
Approved by the State Administration of Machinery and Industry on 1999-06-28 Flange: 4-tube: 5-copper
2000-01-01 In fact
B/T2001.13-1999
605100H
O'SI'Iz HE
8C1'EDOZLEr
ESIICUN JHS
CSL ICNK AT
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.