This standard specifies the classification of product categories of test equipment for special equipment for wires and cables. This standard applies to the compilation of test equipment models for special equipment for wires and cables. The provisions of this standard shall comply with the requirements of JB/T 5824.1. JB/T 5824.4-1991 Classification and code of product categories of special equipment for wires and cables JB/T5824.4-1991 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
Special Equipment for Wires and Cables
Product Category Division and Code
Part 4: Test Equipment
1 Subject Content and Scope of Application
1.1 This standard specifies the product category division of special test equipment for wires and cables. 1.2 This standard applies to the compilation of product models of special test equipment for wires and cables. JB/T5824.491
1.3 The compilation of product models of special test equipment for wires and cables shall comply with the requirements of JB/T5824.1 & Special Equipment and Codes for Wires and Cables Part 1: General Provisions. 2 Category Division and Code
2.1 The product category division and code of online measurement and control equipment for wires and cables shall comply with the provisions of Table 1. 2.2
The product category division and code of special test equipment for wires and cables shall comply with the provisions of Table 2. Table 1 Online measurement and control equipment
Online measurement and control
Approved by the Ministry of Machinery and Electronics Industry on October 17, 1991
Diameter detection
Eccentricity detection
Length measurement
Temperature detection
Spark detectionbZxz.net
Conductor elongation
Thermocouple
Infrared
AC power frequency
AC high frequency
Product category classification
Implementation on October 1, 1992
Additional notes:
Rubber and plastic insulation and
Outer sheath
Paint insulation
JB/T 5824.4-91
Special test equipment for wires and cables
This standard was proposed and managed by the Shanghai Cable Research Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted by Shanghai Cable Research Institute of the Ministry of Machinery and Electronics Industry and other units. The main drafters of this standard are Ou Xuecheng and Wang Yuhui. 156
Reciprocating
Air elastic
Pot with paint scraping
Coat scraping
Drowning green side bending
Asphalt adhesion
Vertical single
Vertical bundle
Voltage test
Softening breakdown
Quick break
Transformer oil resistance
Small side bending
Resilience
ige test
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.