title>HG/T 2257-1991 Determination of volatility of photographic chemicals - HG/T 2257-1991 - Chinese standardNet - bzxz.net
Home > HG > HG/T 2257-1991 Determination of volatility of photographic chemicals
HG/T 2257-1991 Determination of volatility of photographic chemicals

Basic Information

Standard ID: HG/T 2257-1991

Standard Name: Determination of volatility of photographic chemicals

Chinese Name: 照相化学品 成色剂挥发性的测定

Standard category:Chemical industry standards (HG)

state:in force

Date of Release1991-12-28

Date of Implementation:1992-07-01

standard classification number

Standard ICS number:Imaging technology>>Photographic technology>>37.040.30 Pharmaceuticals for photography

Standard Classification Number:Chemicals>>Information Chemicals>>G81 Photosensitive Materials

associated standards

Publication information

other information

Introduction to standards:

HG/T 2257-1991 Determination of volatility of colorants in photographic chemicals HG/T2257-1991 Standard download decompression password: www.bzxz.net

Some standard content:

Chemical Industry Standard of the People's Republic of China
Photographic Chemicals
Determination of Volatile Matter of Color Forming Agents
1 Subject Content and Scope of Application
This standard specifies the method for determining the volatile matter of color forming agents by the oven method. This standard is applicable to color forming agents used in the production of color films, color films and color photographic papers. 2 Method Summary
At a specified temperature, allow volatile substances in a sample of known mass to escape until constant weight is achieved. 3 Instruments or Equipment
3.1 Oven: accuracy of ±2°C,
3.2 Weighing bottle: diameter 55mm, height 35mm or diameter 80mm, height 30mm, 3.3 Balance: sensitivity 0.1mgwwW.bzxz.Net
3.4 ​​Desiccator: filled with color-changing silica gel or anhydrous calcium chloride. 4 Determination method
HG2257-91
Weigh 1g of sample in a constant-weight weighing bottle, accurate to 0.1mg. Put it in an oven and dry it at a specified temperature to constant weight (about 4h). The measurement temperature is generally 105℃. For low-melting-point colorants, the measurement temperature should be 20℃ lower than its melting point. Calculation of measurement results
The mass percentage X of volatile matter is calculated as follows: X
Where: m——the mass of the weighing bottle plus the sample before drying, g; m2—the mass of the weighing bottle plus the sample after drying, g; the mass of the weighing bottle, g.
Measure three times in parallel, the range should not be greater than ±0.04%, and the result is averaged. Approved by the Ministry of Chemical Industry of the People's Republic of China on December 28, 199112
Standard Technology Exchange Network m.baosp:coAll kinds of standard industry information free download 1992-07-01 implementation
Additional remarks:
HG 2257
This standard is proposed by the Science and Technology Department of the Ministry of Chemical Industry of the People's Republic of China, and is managed by the Photographic Chemicals Standardization Technical Management Unit of the Ministry of Chemical Industry. This standard is drafted by Qingdao Dye Factory, and the Photosensitive Materials Technology Development Center of the Ministry of Chemical Industry participated in the drafting. The main drafters of this standard are Hu Jialin, Zhuang Youqin, Wen Huiqiong, and Hu Suqin. Standard Acquisition Network mm.bzeosg.cn13
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.