GB 3743.1-1983 Compression-type right-angle tee pipe fittings
Basic Information
Standard ID:
GB 3743.1-1983
Standard Name: Compression-type right-angle tee pipe fittings
Chinese Name:
卡套式端直角三通管接头
Standard category:National Standard (GB)
state:Abolished
Date of Release1983-06-17
Date of Implementation:1984-04-01
Date of Expiration:2008-11-01
standard classification number
Standard ICS number:21.060.60;
Standard Classification Number:Machinery>>General Parts>>J15 Pipe Accessories
Publication information
publishing house:China Standards Press
Publication date:1984-04-01
other information
Release date:1983-06-17
Review date:2004-10-14
drafter:Hu Lusheng, Liu Dequan, Cheng Zhenshi, Wang Muqin
Drafting unit:Standardization Institute of the Ministry of Machinery Industry
Focal point unit:Standardization Institute of the Ministry of Machinery Industry
Proposing unit:Ministry of Machinery Industry of the People's Republic of China
Publishing department:National Bureau of Standards
competent authority:China Machinery Industry Federation
Introduction to standards:
This standard specifies the ferrule end right angle tee pipe joint, which is suitable for pipeline systems of oil, gas and general corrosive media. GB 3743.1-1983 ferrule end right angle tee pipe joint GB3743.1-1983 Standard download decompression password: www.bzxz.net
Some standard content:
National Standard of the People's Republic of China
Compression-thread run tee-AssemblyUDC 621.648. 4
GB 3743.1—83
This standard specifies compression-thread run tee-Assembly, which is suitable for pipeline systems of oil, gas and general corrosive media.
GB3743.2—83
Marking example:
Nominal pressure level, ferrule-type right-angle two-angle pipe joint with pipe outer diameter Ds of 14mm: Pipe joint J14GB3743.1-83
Published by National Bureau of Standards on June 17, 1983
GB3759-83
GB3764-83
Implementation on April 1, 1984
(Bar)
M27×2
M33×2
M42×2
(M18×2)
M50×2
M27×2
M33×2
Note: The dimensions in the brackets in the d column are limited to old products. GB $743.1—83Www.bzxZ.net
(②) The weight is the sieve value, and the specific gravity is 7.85 kg/dm\. The technical conditions shall be in accordance with the provisions of GB376583.
Wrench size
(kg/100 pieces)
GB 371.1-8
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and drafted by the Standardization Institute of the Ministry of Industry. The Standardization Institute of the Ministry of Machinery Industry of the People's Republic of China was responsible for drafting the standard. The Chongqing Heavy Vehicle Research Institute, Dalian Machine Tool Research Institute, Hangjiang Province Haichuo County Pipe Fittings Factory, Shanghai Electric First Bureau Science and Technology Information Institute, and the Seven-person Institute of the Ministry of Aerospace participated in the drafting of this standard. The main drafters of this standard are Lu Sheng, Liu Dequan, Cheng Shechu, and Wang Jiazhuo
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.