JB/T 7384.16-1994 Fastener rivet hole diameter plug gauge
Basic Information
Standard ID:
JB/T 7384.16-1994
Standard Name: Fastener rivet hole diameter plug gauge
Chinese Name:
紧固件 铆钉孔径塞规
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1994-07-26
Date of Implementation:1995-07-01
standard classification number
Standard Classification Number:Machinery>>General Parts>>J13 Fasteners
associated standards
Publication information
publishing house:Mechanical Industry Press
Publication date:1995-06-01
other information
Drafting unit:Machinery Standardization Research Institute of the Ministry of Machinery Industry
Focal point unit:National Technical Committee for Fastener Standardization
Proposing unit:National Technical Committee for Fastener Standardization
Publishing department:Ministry of Machinery Industry of the People's Republic of China
Introduction to standards:
This standard specifies the type and size of the rivet hole gauge. This standard applies to item 5 of Table 1 of ZBJ13002.6. JB/T 7384.16-1994 Fastener Rivet Hole Gauge JB/T7384.16-1994 Standard download decompression password: www.bzxz.net
Some standard content:
Mechanical Industry Standard of the People's Republic of China
JB/T7384.1～7384.18-94
Special Inspection Fixtures for Fasteners
Published on 1994-07-26
Ministry of Machinery Industry of the People's Republic of China
Implementation on 1995-07-01
Mechanical Industry Standard of the People's Republic of China
Fasteners
Rivet Bore Plug Gauges
Subject Content and Scope of Application
This standard specifies the types and designs of rivet bore plug gauges. This standard applies to item 5 of Table 1 of ZBJ13002.6. Cited standards
GB1957
Smooth limit gauge
ZB J13002.6 Fastener test method
Type and size
Dimension and geometric accuracy of rivets
JB/T7384.16-94
The type and size of the semi-hollow rivet hole diameter plug gauge shall be as specified in Figure 1 and Table 1, and the type and size of the headless rivet hole diameter plug gauge shall be as specified in Figure 1 and Table 2.
Approved by the Ministry of Machinery Industry on July 26, 1994
Implemented on July 1, 1995
Nominal diameter
Basic size
Limit deviation
Basic size
Limit deviation
Basic size
Limit deviation
Nominal diameter d
Basic size
Limit deviation
Basic size
Limit deviation
Report limit deviation
Pengben scale
Limit deviation
Basic size
Limit deviation
JB/T 7384.1694
Nominal diameter d
Basic size
Limit deviation
Basic sizebzxz.net
Limit deviation
JB/T 7384. 1694
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.