JB/T 8007.4-1999 JB/T 8007.4-1999 Machine tool fixture parts and components stud bolts JB/T8007.4-1999 Standard download decompression password: www.bzxz.net
Some standard content:
ICS 25. 080. 01bZxz.net Standard of the Machinery Industry of the People's Republic of China Parts and units of jigs and fixtures The parts and units of jigs and fixtures1999-08-06 Issued State Machinery Industry Bureau Implementation on 2000-01-01 Standard of the Machinery Industry of the People's Republic of China Parts and units of jigs and fixtures The parts and units of jigs and fixturesDouble end stud This standard specifies stud bolts with thread specifications of M6~M30. 2 Referenced standards JB/T 8007.4—1999 The provisions contained in the following standards constitute the provisions of this standard through their use in this standard. When this standard was published, the versions shown were all valid. All standards are subject to revision. Parties using this standard should explore the possibility of using the latest version of the following standards. GB/T 6991988 JB/T8044—1999 3 Dimensions Technical conditions for high-quality carbon structural steel Technical requirements for machine tool fixture parts and components The dimensions are shown in the following figure and table. 4 Technical conditions 4.1 Material: 35 steel in accordance with the provisions of GB/T699. 4.2 Heat treatment: 35~40HRC for the threaded part. 4.3 Other technical conditions in accordance with the provisions of JB/T8044. National Machinery Industry Approved on August 6, 1999 44 Implementation on January 1, 2000 5 Marking 5.1 Marking example: d-M12, L-75mm stud bolt: JB/T8007.4-1999 M12×75JB/T8007.41999 Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.