JB/T 6361.3-1992 Flat head spiral groove nails
Basic Information
Standard ID:
JB/T 6361.3-1992
Standard Name: Flat head spiral groove nails
Chinese Name:
平头螺旋槽钉
Standard category:Machinery Industry Standard (JB)
state:in force
Date of Release1992-07-15
Date of Implementation:1993-01-01
standard classification number
Standard Classification Number:Machinery>>General Parts>>J13 Fasteners
associated standards
Publication information
publishing house:China Machinery Industry Press
Publication date:1993-01-01
other information
Drafting unit:Mechanical Standardization Institute of the Ministry of Machinery and Electronics Industry
Focal point unit:Machinery Standardization Research Institute of the Ministry of Machinery Industry
Proposing unit:National Technical Committee for Fastener Standardization
Publishing department:Ministry of Machinery and Electronics Industry of the People's Republic of China
Introduction to standards:
This standard specifies flat head spiral groove nails with diameter specifications of 2.5~4mm. This standard applies to flat head spiral groove nails for wood structure connection. The products of this standard are commercial fasteners and should be selected as the preferred ones. JB/T 6361.3-1992 Flat head spiral groove nails JB/T6361.3-1992 Standard download decompression password: www.bzxz.net
Some standard content:
Mechanical Industry Standard of the People's Republic of China
Flat-head spiral groove nails
1 Subject content and scope of application
This standard specifies flat-head spiral groove nails with a diameter of 2.5~4mm. This standard applies to flat-head spiral groove nails for wood structure connections. The products of this standard are commercial fasteners and should be used first. Reference standards
GB1237
Marking method for fasteners
JB/T6361.5 Technical conditions for ring groove nails and spiral groove nails 3
Type dimensions
Type dimensions are shown in the figure and table.
b≥41/5;
eSee Article 3.3 of JB/T6361.5
Diameter specification d
Approved by the Ministry of Machinery and Electronics Industry on July 15, 1992Length specification 2
JB/T6361.392
Implemented on January 1, 1993
Diameter specification d
Technical conditions
JB/T6361.3-92
Length specification 1
Technical conditions shall be in accordance with the provisions of JB/T6361.5.
5 Marking
5.1 Marking method shall be in accordance with the provisions of GB1237.
5.2 Marking example
d=3.0mm, l=60mm, A-type nail tip, material is low carbon steel, flat head spiral groove nail without surface treatment Marking example:
JB/T6361.3
Spiral groove nail
Additional instructions:wwW.bzxz.Net
This standard is proposed by the National Technical Committee for Standardization of Fasteners. This standard is under the jurisdiction of the Mechanical Standardization Research Institute of the Ministry of Machinery and Electronics Industry. This standard is drafted by the Mechanical Standardization Research Institute of the Ministry of Machinery and Electronics Industry. 6
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.