HG/T 2956.8-2001 Determination of loss on ignition in boron and magnesium ores - Gravimetric method HG/T2956.8-2001 Standard download decompression password: www.bzxz.net

1cs 73.080
Chinese Chemical Industry Standard
HG/T 2956.2~2956.82001
Analytical methods for ascharite ores2002-01-24Promulgated
2002.0701Implementation
Promulgated by the State Economic and Trade Commission
No.:101052002
HG/T 2966.8—2001
This standard is recommended by the chemical industry standard HG/T2956.3—1!%2Analysis of loss on ignition in ascharite as a method for the revision of the surface,
This standard shall be replaced by HG/T2956.8—1932 from the month of implementation. This standard is under the jurisdiction of the State Petroleum and Chemical Industry Bureau and the Ministry of Chemical Industry's Lianyungang Institute of Standardization. The drafters of this standard are Wang Heping and Zhang Xiaoqi. This standard was first issued in 1985 as the chemical industry standard HG1-32-65% primary ore - analytical method 3; it was issued in 1982 as the national standard (H3447.8-824) and then adjusted to the recommended chemical industry standard in 1997. The original national standard GB3447.8-82 was renumbered as HG/T2256.81882. 24
Chemical Industry Standard of the People's Republic of China
Determination of loss on ignition in iodine-magnesium ore
Gravimetric method
Ascbarlte orey-
ignitiun-
Dhetereinaliun of loss o0
Grnriretrie The standard specifies the ignition loss of magnesium ore. This standard is used for the determination of ignition loss of magnesium ore. 2. Method summary
IG/T2956.8-2001
H/12956.8—=982
The mass lost by burning the sample at X50℃ is the ignition loss, which mainly includes combined water, carbon monoxide, sulfide and organic matter. The substances are oxidized and the mass increases rapidly during the burning process. The ignition loss is the algebraic sum of the amount of each chemical reaction during the burning of the sample. 3. The sample passes through a 125um test sieve (GB/T6003.1), is heated at 105~11℃ for more than 2h, and is cooled to room temperature in a desiccator. 4. Analysis step
Weigh 1g sample (0.0002g is correct), place it in a crucible that has been heated to a constant temperature, move it into a high-temperature furnace, gradually raise the height by 1080° to 1.51°, take it out, cool it, place it in a drying oven to cool for 30 minutes, weigh it, repeat the heating for 30 minutes, and weigh it.
5 Expression of analysis results
The ignition loss (x) expressed as a percentage of mass point is calculated by formula (1): X
Where: wwW.bzxz.Net
is the mass of the sample and the crucible before ignition,
is the mass of the sample after ignition,
is the mass of the sample after ignition.
Approved by the Economic and Trade Commission 2D 2-01-24 ×10G
2002-07-01
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.