JB/T 2462.20-1999 This standard is a revision of JB 2516-78 "Nominal dimensions and interchangeable dimensions of columns (for long table slides) of common components of modular machine tools". Only editorial modifications have been made according to relevant regulations, and the main technical content has not changed. This standard specifies the interchangeable dimensions of the nominal dimensions of the columns (for long table slides) of modular machine tools. This standard applies to columns for long table slides of modular machine tools and their automatic lines. This standard was first issued in 1978. JB/T 2462.20-1999 Dimensions of columns (for long table slides) of common components of modular machine tools JB/T2462.20-1999 Standard download decompression password: www.bzxz.net

1C25.6.99
Machinery Industry Standard of the People's Republic of China
JB/12462.1~2462.28-1999
Combination Machine Tool Common Components
1990-05-21 Issued
National Machinery Industry Bureau
2(MI-01-1 Implementation
JB/T2462.20—[999
Vertical Column! Long Table Front Slide) Nominal Size, Point Change Size Small Individual Swing Foot Parts: Revised on the Basis of B251678 Classified Machine Tool Components System.
578 has no technical content consistent, only the relevant provisions have been re-adopted: This standard is the same as JB2516
This standard is called the standard for the implementation of the current group 2516-78.
This standard is proposed by the National Association for Standardization of Machine Tools, and is under the jurisdiction of the National Association for Standardization of Machine Tools. The responsible unit for this standard is the China Machine Tool Research Institute. This standard was first issued in 1978.
1 Scope
Machinery Industry Standard of the People's Republic of China
Common Parts of Combined Machine Tools
Used for Long Tables
This standard specifies the size and size of combined machine tools (long tables also known as long tables). This standard applies to the total length of the combined bed and the nominal size of the columns and sliding parts. The support is based on the required length of the corresponding platform surface as 8 as the nominal size, divided into 100mm, 125mm, 160mm, 201mm, 250mm types, the interchangeable size of the columns shall comply with the table and figure requirements, the table shows the length of the columns and the length of the platform surface. The installation of the sliding platform is ||Width of column
Center of screw hole
Fasten boltbzxZ.net
Approved by National Machinery Industry Week on May 2, 1999
Implemented on January 1, 2000
1C, G, both are 25mm
JE/T2462.20-1999
2 Before installing the slide, the glass needs to be opened in the longitudinal direction (direction: or direction: the width R, smaller) and the size is shown in the current slide of the school.
3 When the surface is pinned and positioned, the chain increases by a number of times.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.